DuraLabel PRO 300 Especificações

DuraLabel ® PRO 300 THERMAL TRANSFER PRINTER Graphic Products, Inc. PRINTER MANUALv.1.0Graphic Products, Inc. 1-800-788-5572 www.DuraLab

4. To close the cover, lift the top cover all the way up then lower the top cover gently. Use both hands to gently push down the top cover to close it

4. Power on Utilities There are three power-on utilities to set up and test printer hardware. These utilities are activated by pressing FEED button a

While calibrating the gap/black mark sensor, the printer will measure the label length, print the internal configuration and then enter the dump mode.

The printer will enter dump mode after printing the printer configuration. In the dump mode, all characters will be printed in two columns as follows:

4.3 Initialization Printer initialization is used to clear DRAM and restore printer settings to defaults. The only one exception is ribbon sensitivit

5. Maintenance 5.1 Cleaning Use one or more of the following supplies that meets your needs: Cleaning pens Cleaning swabs Lint-free cl

6. Troubleshooting This section provides possible solutions to common printing, operating, and LED status problems you may encounter. 6.1 LED Status

6.2 Print Quality Continuous feeding labels  The printer setting may go wrong. Please do the Initialization and Gap/Black Mark Calibration. (See pa

7. Specifications 7.1 Printer Specifications Item DLPRO 300 Mechanism Resolution 300 dpi. Max. Print Width 4 in. Max. Print Length 40 i

2D Bar code PDF-417, Maxicode, and DataMatrix, QR CODE Command Set TSPL-EZ™ Environment Operation Temperature: 41°F ~ 104°F (5°C ~ 40°C). R

Contents 1. Introduction ... 2. Getting Started ...

8. LED and Button Operation 8.1 LED LED Color Description Green This shows that the power is on and the device is ready to use. Orange

8.2 Button Operation Feed Press the button when the LED is green.   It feeds the label to the beginning of the next label. Pause Press

9. Warranty The Graphic Products DuraLabel PRO 300 is warranted to be free from defects in materials or workmanship for a period of two years from th

1. Introduction Thank you for purchasing the DuraLabel® PRO 300 Thermal Transfer Printer. Although the printer takes only a small amount of space, it

2.3 Printer Parts Fig. 1 Top front view Fig. 2 Rear view 1. USB Interface 2. Centronics Interface 3. RS-232 DB-9 Interface 4. Power J

3. Setup 3.1 Setting Up the Printer 1. Place the printer on a flat, secure surface. 2. Make sure the power switch is off. 3. Connect the printer

Make sure both the ribbon access window and the printer top cover are closed when powering up the printer. 1. Push down on the ribbon access window t

Fig. 5 Ribbon installation (II) 3.3 Loading Label Stock The ribbon and various print media for the DuraLabel® PRO 300 have been optimized f

Fig. 7 Pull the lever to open the cover 3. Place a roll of label stock onto the center of the paper roll mount. 4. Feed the label stock, printin

3.4 Instructions to Top Cover Operation Please take care when opening or closing the printer’s top cover by carefully following these instructions.